WeMos Matrix Shield Versions Save

• added experimetal support for ESP32 boards with WeMos Mini D1 wiring called ESP32 Mini Kit or ESP32 Wemos, or ESP32 MH-ET Live.
• PCB board has been extented to fit this ESP32 Mini module but also backward compatible with WeMos Mini D1 ESP8266.

New in V1.5

• changed power connector spacing to fit the same than Matrix one's #4
• added space for smaller Matrix power connector #4
• generated gerbers files

• Added DS18B20 footprint + 4K7 PullUp resistor (DS18B20 DQ connected to GPIO0/D7)
• Removed E connection to add DS18B20 (DQ PIN), added solder jumper if needed this connection back.
• added space for barrel DC connector if connector input connector is top soldered see #3
• Changed LDR orientation

New in V1.3

• Fixed missing trace missing beetwen Input and Output connector G1. That was cutted by accident when creating V1.2 from V1.1.
• Added footprint for a Photoresistor (LDR) + Resistor to be able to adjust luminosity with ambiant light

New in V1.1

• Power, added big connector 3.5mm spaced to put the supplied power cable
• Changed 3.5mm Phoenix connector by a 5mm one allowing the stronger power cable to fit info
• Moved output connector to the right you can use the supplied flat band connector
• Output connector can go straight to output connector of Matrix, allowing to use a 6 PIN ISP Arduino Like ribbon cable.
• Increased PCB traces width for 5V power
• Added some wiring info on bottom silk

Creation