Printrboard and Modern Marlin
RevD with CDC Bootloader
SD Card Support LCD Support REPRAP_DISCOUNT_SMART_CONTROLLER PID Extrusion Scaling M301 Read More
Build Volume area can be changed using M206 and M428 Set Home offsets here
I've enabled No_timeouts and Advanced_ok to help keep serial connection active
PlatformIO Environment Configuration
[env:at90usb1286_dfu]
platform = teensy
board = at90usb1286
lib_ignore = TMCStepper
lib_deps = ${common.lib_deps}
src_filter = ${common.default_src_filter} +<src/HAL/HAL_AVR>
monitor_speed = 250000
The DFU Bootloader is installed on most printrboards
SD Card Support LCD Support REPRAP_DISCOUNT_SMART_CONTROLLER
M301 PID Extrusion Scaling Read More
Build Volume area can be changed using M206 and M428 Set Home offsets here
I've enabled No Timeouts and Advanced Ok to help keep serial connection active
PlatformIO Environment Configuration
[env:at90usb1286_dfu]
platform = teensy
board = at90usb1286
lib_ignore = TMCStepper
lib_deps = ${common.lib_deps}
src_filter = ${common.default_src_filter} +<src/HAL/HAL_AVR>
monitor_speed = 250000
Heated bed and non heated bed versions. Make sure to run PID autotune if your are using an E3D hotend.
Printrboard RevF
Adopt-A-Bot Build Volume 100x100x125 Printrboard RevF Two versions: No probe - Manual Mesh Bed Leveling with paper Inductive - Probe with normal 3 point leveling
Play V2 Build Volume is 200x170x190 1.Save your current settings EEPROM M501 2. Find your model, download 3. Flash using FLIP 4. Calibrate 5. Have Fun
1.Save your current settings EEPROM M501 2. Find your model, download 3. Flash using FLIP 4. Calibrate 5. Have Fun
The heated bed versions on this release don't have heated bed enabled.
updated firmware with Junction deviation and linear advance Play with heated bed and LCD SD card support is disabled to save program space