Adds some convenient commands to pongoOS
Using this module, the following 3 commands will be available in pongoOS shell:
mread 0xaaaaa
. The only supported input format is hex in lower case. Please also pay attention to the space, only one space is allowed
The output will be a DWORD (little endian)mwrite 0xaaaaaaaa f 0xbbbbbbbb
. 0xaaaaaaaa is the target addr to write, f is the writing width, and 0xbbbbbbbb is the value to be written. Addrs' format is same as above, and f can be b,w,d,q which refers to bytes, word, dword, qword.dis 0xaaaaaaaa [0xbbb]
, 0xaaaa is the address to be disassembled; 0xbbbb is number of instructions to disassemble, which could be omitted.mfind 0xaaaaaaaa 0xbbbb 0xcccccccc 0xdddd
0xaaaaaaaa: start address, 0xbbbb: search length, 0xcccccc: pattern in uint64_t, 0xdddd: pattern lengthhexdump 0xaaaaaaaa [0xbbbb]
, 0xaaaaaaaa is the address, 0xbbbb is dump length$ git clone https://github.com/checkra1n/PongoKit
$ cd PongoKit
$ git clone --recursive https://github.com/NyaMisty/PongoHelper test
$ cd test
$ ./make.sh
$ python ../scripts/module_load.py test_module
You should build first, but if you want a binary, you can find the built test_module in the repo
$ python ../scripts/module_load.py test_module
$ python ../scripts/issue_cmd.py dumpvars