OpenTendo Versions Save

An Open-Source HardWare (OSHW) recreation of the original 1985 front-loading NES Motherboard

V1.2

3 years ago
  • Fixed errors in BOM
  • Fixed outdated RF Modulator footprint
  • Added silkscreen denoting PAL and NTSC X1 frequencies (see note about X1 frequencies below)
  • Added mask layer to edge connector to remove soldermask from the mating surfaces
  • Added JST footprint for future open source power/reset button PCB

Notes:

The X1 crystal in the BOM is for an NTSC board, if you want to make a PAL board, you will need to use a PAL CPU, a PAL PPU, and a PAL crystal (26.601712MHz) instead of NTSC.

A few parts aren't in the BOM due to mainstream component suppliers not stocking them, so they will have to be bought separately.

They include 1 30pF trimmer capacitor (Can be found on Aliexpress), 1 4-resistor 6.8K common bus resistor array (Can be found on ebay or similar sites), 2 DAN601 diode arrays (Can be found on UTSource), 2 UPA64H diode arrays (Also UTSource), 1 2SA937 transistor (Can be found on Ebay), and 2 2SC2021 transistors (Also Ebay).

You will of course have to source either an original CPU and PPU, or aftermarket parts.

V1.1

3 years ago

ONES-CPU-01 V1.1

+Added plated layer to edge for RF shield +Improved silkscreen to list unused parts as unused, and fixed overlapping labels +Moved OSHW logo to accommodate the new plated area +Added thermal reliefs to make soldering to power/ground pins easier +Removed redundant files

Note: A few parts aren't in the BOM due to mainstream component suppliers not stocking them, so they will have to be bought separately.

They include 1 30pF trimmer capacitor (Can be found on Aliexpress), 1 4-resistor 6.8K common bus resistor array (Can be found on ebay or similar sites), 2 DAN601 diode arrays (Can be found on UTSource), 2 UPA64H diode arrays (Also UTSource), 1 2SA937 transistor (Can be found on Ebay), and 2 2SC2021 transistors (Also Ebay).

You will of course have to source either an original CPU and PPU, or aftermarket parts.

V.1.0

4 years ago

Completed BOM, updated Gerbers, and added .PDF schematic.

Note: A few parts aren't in the BOM due to mainstream component suppliers not stocking them, so they will have to be bought separately.

They include 1 30pF trimmer capacitor (Can be found on Aliexpress), 1 4-resistor 6.8K common bus resistor array (Can be found on ebay or similar sites), 2 DAN601 diode arrays (Can be found on UTSource), 2 UPA64H diode arrays (Also UTSource), 1 2SA937 transistor (Can be found on Ebay), and 2 2SC2021 transistors (Also Ebay).

You will of course have to source either an original CPU and PPU, or aftermarket parts.