Driver Versions Save

DEPRECATED: Updated Linux drivers for the ATWILC1000/ATWILC3000 products are located at https://github.com/linux4microchip/linux/tree/master/drivers/net/wireless/microchip/wilc1000. To simplify development, the legacy Linux4WILC was merged into the Linux4Microchip repo where driver development continues (Please refer latest ATWILC1000/ATWILC 3000 Wi-Fi Link Controller Linux User Guide) Driver code for Microchip ATWILC Wireless Devices (ATWILC1000 & ATWILC3000)

wilc_linux_15_3_1

4 years ago

Changes since release 15.3:

Bug Fixes:

  1. Ignore errors from clockless registers in sleep mode.
  2. Fix for iperf stalls during longevity tests

wilc_linux_15_3

4 years ago

Changes since release 15.2: New features:

  1. Reed IQ imbalance calibration data from Efuse.
  2. Dynamically add network interfaces for ATWILC driver.
  3. Add optional rtc_clk property to dts and use it in the driver.

Bug Fixes:

  1. Apply feedback comments from staging community to the driver.
  2. Fix for CF-End packets on air when multiple WILC stations are connected to the same AP.
  3. Fix crack Attack failure – Upgrade wpa_supplicant on buildroot to 2.7 and latest security fixes.
  4. Fix memory leak when connecting/disconnecting to AP continuously.
  5. Fix for Passive scanning feature.
  6. Avoid controlling power save state from the driver while obtaining IP and scanning.
  7. FW crash when switching between AP via link loss.
  8. Fix for low Tx power when using CW Tone in the Ch/C GUI tool.
  9. Clear pending interrupts while initializing/de-initializing the device.
  10. WILC3000 Low Rx performance with 11n rates.

wilc_linux_15_3_rc2

4 years ago

New features:

  1. Add optional rtc_clk property to dts and use it in the driver

Fixes:

  1. 3000SDIO/SPI:BLE feature is inconsistent
  2. FW crash when switching between AP via link loss
  3. Ch/C GUI Low Tx power in CW Tone
  4. Changing p2p from client to Go without having to reboot the host

wilc_linux_15_3_rc1

4 years ago

New features:

  1. Read IQ imbalance calibration data from Efuse.

Fixes:

  1. Apply feedback comments from staging driver.
  2. Fix for CF-end packets on air when multiple WILC stations are connected on the same AP.
  3. Memory leak when keep connecting/disconnecting to AP.
  4. Fix for Passive scanning feature.
  5. Dynamically add network interfaces for wilc driver.
  6. Avoid controlling powersave state from the driver while obtaining IP and scanning.
  7. Fix WILC3000 Wakeup retry sequence. #44
  8. Success message logged as ERR #55
  9. Make sure the FW finishes the wakeup sequence before the CPU is reset

wilc_linux_15_2_1

5 years ago

wilc_linux_15_2

5 years ago

wilc_linux_15_2_RC1

5 years ago

wilc_linux_2018_06

5 years ago